How to Assemble a Two-Drawer Nightstand with Curved Edges and Raised Sides

Step 1: Unboxing & Organizing

Instruction: Carefully remove all parts from their packaging. You should have two side panels (each with a curved top edge), a bottom panel, a back panel, a top tray panel, two drawer fronts (white, rounded edges), and the corresponding drawer side pieces, bottoms, and hardware (screws, bolts, drawer knobs). Lay everything out on a clean surface, verifying each part against your assembly manual.

Image 1 (Wide Shot): The wooden side panels, bottom panel, top tray piece, white drawer fronts, drawer sides, and labeled hardware packets are neatly spread on the floor. A small toolkit (screwdriver, hex key) is placed to one side, ready for assembly.

Step 2: Building the Main Frame

Instruction: Identify the two side panels. Attach the bottom panel between them using the provided bolts or screws. Keep the hardware slightly loose to allow for minor adjustments. Next, secure the back panel, aligning it with the edges of the side panels. Finally, position the top tray panel on the upper edges of the side panels, ensuring the curved sides match up neatly. Tighten all screws once the frame is aligned.

Image 2 (Wide Shot): The partially assembled nightstand frame stands upright, with a hex key being used to tighten bolts at each corner. A few extra screws lie close by, indicating ongoing assembly.

Step 3: Assembling the Drawers

Instruction: Construct each drawer by connecting its side panels, bottom board, and the rounded white front panel. If the drawer knobs aren’t pre-installed, attach them from the inside of each front panel. Repeat for both drawers.

Image 3 (Wide Shot): Two drawer boxes, each with a white front panel and a small round knob, are shown partially assembled on the floor. A screwdriver is visible, fastening the final screws for the drawer sides.

Step 4: Installing the Drawers & Adjusting

Instruction: Carefully slide each assembled drawer into the designated rails inside the nightstand frame. Test them by gently pulling in and out to ensure a smooth glide. If they catch or stick, adjust the rails or tighten any loose screws.

Image 4 (Wide Shot): The nightstand is upright, with each drawer partially open to demonstrate smooth gliding. A small bag of screws is on the floor, used for final rail adjustments.

Step 5: Final Checks & Placement

Instruction: Gently shake the entire unit to confirm stability. Tighten any remaining bolts or screws, then wipe down all surfaces with a soft cloth to remove dust or fingerprints. Finally, place your new nightstand next to the bed—use the top tray for decorative items or a glass of water, and keep personal belongings neatly stored in the two drawers.

Image 5 (Wide Shot): The fully assembled nightstand stands in a bright bedroom, drawers neatly closed, and the raised top tray styled with a small vase and a cup.

Conclusion

By following these five steps, you’ll have a charming, two-drawer nightstand that combines a warm wooden finish with sleek white accents. Its curved edges and raised sides help contain items on top, while the spacious drawers keep essentials within reach. Enjoy your newly assembled piece and the subtle style it adds to your space!