How to Assemble a Carved-Drawer Nightstand with Open Shelf

Step 1: Unboxing & Organizing

Instruction: Carefully remove all parts from the packaging. You should have two side panels (extending above the top shelf), a bottom panel, a back panel, an open shelf board, one carved drawer front, plus drawer side pieces and bottom, and four tapered legs. Lay everything out on a clean surface, checking each item against your assembly manual.

Image 1 (Wide Shot): The wooden side panels, bottom panel, open shelf board, carved drawer front, drawer sides, and labeled hardware packets are neatly spread on the floor. A small toolkit (screwdriver, hex key) rests to one side, ready for assembly.

Step 2: Building the Main Frame

Instruction: Identify the two side panels and attach the bottom panel between them using the provided bolts or screws. Keep the hardware slightly loose so you can adjust alignment if needed. Next, secure the back panel, ensuring it lines up with the edges of the side panels. Finally, position the open shelf board at the designated height, fastening it with screws from inside.

Image 2 (Wide Shot): The partially assembled nightstand frame stands upright, with a hex key being used to tighten bolts at each corner. A few extra screws lie close by, indicating ongoing assembly.

Step 3: Attaching the Legs

Instruction: Flip the nightstand carefully onto its back or side. Align each tapered leg with the pre-drilled holes at the bottom corners. Secure them with bolts or screws, leaving them slightly loose until all four legs are in place. Once aligned, tighten the hardware evenly for stability.

Image 3 (Wide Shot): The nightstand lies on its side, with a screwdriver fastening one of the tapered legs. Extra screws are visible on the floor, ready for final adjustments.

Step 4: Assembling & Installing the Drawer

Instruction: Construct the drawer by connecting its side panels, bottom board, and the carved front panel. If the handle or knob isn’t pre-installed, attach it from the inside of the drawer front. Carefully slide the assembled drawer onto the rails inside the nightstand, ensuring it opens and closes smoothly.

Image 4 (Wide Shot): The drawer box, featuring a carved front, is shown partially assembled on the floor. A screwdriver is tightening the final screws for the drawer sides, while the carved design is clearly visible.

Step 5: Final Checks & Personalization

Instruction: Gently shake the entire unit to confirm stability. Tighten any remaining bolts or screws, then wipe down the wooden surfaces with a soft cloth to remove dust or fingerprints. Finally, place your new nightstand next to your bed—use the open shelf for books or a charging station, and keep personal items tucked away in the carved-front drawer.

Image 5 (Wide Shot): The fully assembled nightstand stands in a bright room, drawer neatly closed, showcasing its carved design and open shelf above.

Conclusion

By following these five steps, you’ll have a distinctive nightstand that combines a carved drawer front, convenient open storage, and stylish tapered legs. Its warm wood finish and curved side panels add a unique flair, making it a functional and eye-catching addition to your bedroom. Enjoy your newly assembled piece and the practical storage it provides!